Rommelsbacher TA 1200 Instruction Manual download pdf (Page 17)

The following table shows the pre-deﬁned brewing temperatures (guide values) and times:

Programme Predeﬁned

brewing temperature

(not adjustable)

Predeﬁned

brewing time

(adjustable)

Display

1 100 °C (boiling) 06:00 minutes HERBAL (herbal tea, fruit

infusion)

2 100 °C (boiling) 03:00 minutes BLACK (black tea)

3 90 °C 03:00 minutes OOLONG (Asian tea type)

4 85 °C 03:00 minutes WHITE (white tea)

5 80 °C 03:00 minutes GREEN (green tea)

• The appliance has an electronic control. Each function or operating step is acknowledged by one or several

signal tones.

• If the appliance is switched on and there is no further button pressed within 60 seconds, the appliance will

switch into standby mode with one beep and the display will extinguish.

• You will hear several “CLICK” sounds during the tea making process. This is normal and will not result

in a damage of the appliance.

1. Preparing the appliance

• Connect the appliance to the mains. It is in standby mode now. This is acknowledged by an audible double signal.

• Open the lid of the water container and cautiously ﬁll in cold water. Observe the “min” and “max” marking of

the level indicator.

Note: Induced by the system, the water container will drain completely in case of overﬁlling (> 1 litre

of water).

• Only close the lid of the water container after the complete water has run off into the container. The lid must

stay closed during the complete tea making time!

• Pull out the ﬁlter jug and remove the lid.

• Take the strainer out of the ﬁlter jug and put it on the worktop for ﬁlling.

• To ﬁll the strainer with loose tea, position the ﬁlling funnel onto the tea strainer and ﬁll in some tea using the

attached tea scoop. Remove the funnel and put the strainer back into the center of the ﬁlter jug.

Note: You may as well put tea bags with pre-portioned tea into the strainer.

• Put the lid on the strainer jug and insert it into the appliance from the front until the jug engages.

• Make sure that teapot and ﬁlter jug are inserted correctly into the appliance.

Otherwise it is not possible to start the appliance.

2. Selecting programme and brewing temperature

• To activate the tea maker you have to push the “MENU“ button. The appliance will quit the standby mode

and the desired programme can be selected by touching the “MENU“ button several times.

WARNING: Hazard of injury and burns! During operation, surfaces

are getting hot (e.g. appliance, teapot, ﬁlter jug, strainer and hot

plate) and might stay hot also after switch-off for a while!

Operating the appliance

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Rommelsbacher TA 1200 Instruction Manual Page 17